Post by davem on Dec 4, 2008 9:35:00 GMT 1
is it a fairly easy job ?
I fitted a 240v/12v socket that uses the same housing earlier this year and it was quite an easy job. Once the hole is cut out you have to remove some of the insulation in between the panels and replace this with wooden batten. This is glued into place and when dry allows you to screw the housing into place.
I installed quite a lot of gas fittings on KevR's camper but if you are not happy with gas get someone else to do it or at least check it afterwards.
If it does not make sense then give me a call
regards
Dave
p.s. watch out for hidden wires when cutting holes in caravans/campers eh Collin
